In this system, RF coils of 0.6 mm inside diameter was chosen. A photograph of the RF coil click here used is shown in

Fig. 1. It consists of 5 turns of 0.06 mm polyurethane coated copper wire, so that it might be easy to insert between the GDL and PEM. Since fuel gas can pass through the hole in the central part of the RF coil, its insertion has little influence on the power generating capability of the PEFC. As shown in Fig. 2, a RF coil can acquire the NMR signal from the water contained in a PEM without attenuating the electromagnetic waves by feeding the signal along a cable in a hole that penetrates the GDL, carbon plates and metal end-plate, and contacting the coil to the PEM. Eight RF coils were inserted between the PEM and the air-side of the GDL which constitute the PEFC at intervals of 6 mm between the gas inlet and outlet. The electromagnetic waves emitted from the planar surface coil for the excitation of the nuclear magnetization of water are decreased in the normal direction by the highly conductive Dinaciclib research buy GDL fibers. When adjusting the excitation angle of the nuclear magnetization of the water in the MEA to about 90°, that of the water in the GDL becomes very small due to this reduction effect of electromagnetic waves. As a result, the NMR signal of the water in the GDL is acquired as a very small signal compared to that of the water in the MEA. In order to detect a weak NMR signal, a resonant

circuit using the small planar RF coil was manufactured. As shown in Fig. 2, the resonant circuit was made by connecting two capacitors to the RF coil using a coaxial cable (1.5D; characteristic impedance = 50 ohms)

with a specific length. This is because the inductance of the small RF coil can be increased by using a coaxial cable of a specific length. Hence, the inductance component of the resonant circuit can be adjusted by the length of the coaxial cable, LC. When the length of the coaxial cable LC was 0.73 m and the capacity of the two variable capacitors were adjusted to CM = ∼20 pF and CT = ∼30 pF, the center frequency of the resonant circuit was set to 44 MHz. The impedance of the resonant circuit was 50 ohms at the center frequency. Since the resonance frequency and impedance of the resonant circuit are Isotretinoin adjusted with a capacitor, henceforth, the resonant circuit is called a tuning circuit. The quality factor (Q value) of the resonant circuit was about 20. A block diagram of the full NMR system is illustrated in Fig. 3. The system has eight sets of RF coils, tuning circuits, switches, modulators and detectors set up as eight channel parallel transceivers. The system was built by MRTechnology, Inc. [14]. The system had an oscillator (DDS) installed in a PC control unit. The frequency of the oscillator was set to the resonance frequency of NMR signal from 1H. The RF signal generated by the oscillator was distributed to eight modulators and detectors.