I-V curves in the (a) initial state and (b) high and low resistan

I-V curves in the (a) initial state and (b) high and low resistance states of the Ni/PCMO/Pt device. The inset magnifies

the behavior near the origin. (c) Resistance switching behavior of the Ni/PCMO/Pt device. Figure  3a 4SC-202 datasheet shows I-V characteristics in the initial state of the Ag/PCMO/Pt device. The I-V hysteresis was absent as well as the initial state of the Ni/PCMO/Pt device. After adding an electric pulse of 10 V, however, the resistance of the device was decreased, and a hysteretic behavior shown in Figure  3b was observed. Increasing the negative voltages switched the low resistance state to the high resistance state. The Ag/PCMO/Pt device showed an opposite switching direction to the Al/PCMO/Pt and Ni/PCMO/Pt

devices in the I-V characteristics. Figure  3c shows the resistance switching in the Ag/PCMO/Pt device. The pulse amplitude was 10 V. The switching polarity of the Ag/PCMO/Pt device was opposite to that of the Al/PCMO/Pt and Ni/PCMO/Pt devices. This corresponds to the opposite polarity dependence in the I-V characteristics. Figure 3 I – V curves and resistance switching behavior of the Ag/PCMO/Pt device. I-V curves in the (a) initial state and (b) high and low resistance states of the Ag/PCMO/Pt device. (c) Resistance this website switching behavior of the Ag/PCMO/Pt device. Figure  4a shows I-V characteristics in the initial state of the Au/PCMO/Pt device. The I-V characteristics exhibited no hysteretic behavior. Even after adding an electric pulse of 10 V, nonswitching behavior was observed in the I-V characteristics. Figure  4b shows the behavior of the resistance in the Au/PCMO/Pt device. The pulse amplitude was 10 V. No significant resistance change was observed. This corresponds to the nonswitching I-V characteristics. Figure 4 I – V curve and resistance switching behavior of the Au/PCMO/Pt device. (a) I-V curve of the Au/PCMO/Pt device. (b) Resistance switching behavior of the Au/PCMO/Pt

device. In order to study the resistance switching mechanism in the PCMO-based devices, the frequency response of complex impedance of the PCMO-based devices was measured. Impedance spectroscopy indicates whether the overall resistance of the device is dominated by a bulk or interface component. We investigated the resistance switching behavior by comparing impedance spectra between high Acyl CoA dehydrogenase and low resistance states. Figure  5 shows impedance spectra of the Al/PCMO/Pt device. Two semicircular arcs were observed in the Cole-Cole plot. The semicircular arcs in the high and low frequency regions are assigned to the bulk and interface components, respectively [32]. The decrease in the diameters of both semicircular arcs was observed by switching from the high to low resistance states. The switching from the low resistance state to the high resistance state doubled the bulk impedance, while the interface impedance increased about 60 times simultaneously.

Comments are closed.